The evaluation of impedance parameters shows electrochemical reaction impedance of metal/ electrolyte interface is primarily determined by water uptake in coatings. The water sorption of coatings directly determines electrochemical reaction area of base metal/ electrolyte interface.

1、

The results of electrochemical impedance spectroscopy ( EIS) indicate that the electrode polarization reduces and hence the increase of the electrochemical reaction impedance of cathode is restrained after composite doping during cycling.

电化学阻抗谱（EIS）测试结果表明，复合掺杂降低了该材料的电化学极化，抑制其在循环过程中电化学反应阻抗的增加。

互联网摘选

2、

With increasing flow velocity the shear stress on the metal electrode surface and the electrochemical corrosion rate increased, and the electrochemical reaction impedance decreased.

随着流速增大，电极表面受到的切应力增大，反应阻抗减小，电化学腐蚀加速，协同效应增强，结果使电极流动腐蚀速度增加。

互联网摘选

3、

With the increasing content of bismuth, the reaction impedance of the Pb-Ca-Sn-Al-Bi alloy has decreased gradually.

随着铋含量的递增，铅钙锡铝铋合金反应电阻逐渐降低。

互联网摘选

4、

But the reaction impedance decreased, and then the corrosion rate increased.

但极化条件下反应电阻下降，反应速率加快。

互联网摘选

5、

Electrochemical reaction impedance of the MH electrode decreased with the increase of depth of discharge, and increased when the DOD was above 80% in discharge process.

在放电过程中，贮氢电极表面电化学反应阻抗随放电深度增加而减小，当放电深度大于80%时电化学反应阻抗又增大。

互联网摘选

6、

Following is concluded: non-crystalline Ni-19.2P alloy has good corrosion resistance because of its high stable potential, polarization resistance and reaction impedance.

结果表明：Ni-19.2P非晶态合全稳定电位高，极化阻力和反应阻抗大，腐蚀速率小，具有优良的耐蚀性能。电化学测量技术是研究镀层耐蚀性能快速有效的方法。

互联网摘选

7、

Reaction hysteresis synchronous motor

反应式磁滞同步电动机

互联网摘选

8、

Backstepping Based Adaptive Sliding Mode Control for PMSM reaction hysteresis synchronous motor

永磁同步电机的自适应反演滑模变结构控制反应式磁滞同步电动机

互联网摘选

9、

A molecular lumped kinetic model has been established based on the classic carbonium ions reaction mechanism to represent the FCC gasoline reaction network through reasonable hypothesis and simplification.

应用经典正碳离子反应机理合理简化催化裂化汽油的催化反应网络，建立了一种接近分子水平的集总反应动力学模型；

互联网摘选

10、

This reaction, the hypothesis goes, is responsible for the recent increase in asthma and allergies, both associated with inflammation.

该假说认为，目前与炎症相关的哮喘与过敏症呈增长态势，与该反应机制密切相关。

互联网摘选

11、

Machinable 3Y-TZP/ BN ceramic nanocomposites with BN dispersoids ranging from 10 to 30% ( volume fraction, the same below) were prepared via in-situ reaction and subsequently hot-pressing.

利用化学包覆和热压烧结制备出3Y-TZP/BN纳米复相陶瓷，BN体积分数分别为10%~30%。

互联网摘选

12、

Ti-Al composites, reinforced with Al2O3 particles and whiskers, were synthesized by in-situ reaction hot-pressing method and embedding sintering method respectively.

采用原位反应热压与覆埋烧成工艺，分别制备了Al2O3颗粒与晶须增强Ti-Al基复合材料。

互联网摘选

13、

Nb-doped Al_2O_3/ TiAl Composites Synthesized by In-situ Reaction Hot-pressing Processes

原位热压合成Nb掺杂Al2O3/TiAl复合材料

互联网摘选

14、

Mechanical and Tribological Properties of c/ w_2b_5 composites fabricated by reaction hot-pressing

反应热压制备C/W2B5复合材料的力学和摩擦磨损性能

互联网摘选

15、

Research on Mechanical Properties of SiC/ MoSi_2 Composites Prepared by Technology of In-situ Reaction Hot-pressing Sintering

原位反应热压烧结SiC/MoSi2复合材料的力学性能研究

互联网摘选

16、

Influence of sintering additive on the performance of B_4C based composites sintered by reaction hot-pressing

烧结助剂对反应热压烧结B4C基复合材料性能的影响

互联网摘选

17、

In-situ reaction hot-pressing sintering process of SiC/ MoSi_2 composites

SiC/MoSi2复合材料的原位反应热压烧结工艺

互联网摘选

18、

As the inlet flowrate increases, the conversion rate and the ratio of reaction heat decrease.

入口流量越大，反应转化率越小，化学反应吸热量占总吸热量的比例越小；

互联网摘选

19、

Full utilization of chemical reaction heat and increment of vapour pressure of industrial and waste boilers;

充分利用化学反应热，提高自备工业锅炉和废锅发汽压力；

互联网摘选

20、

Determination of the Reaction Heat for Natrium and H_2O in Oxygen Bomb

用氧弹量热计测定钠与水的反应热

互联网摘选